Author Topic: CISCO SWITCH CONFIGURATION FROM LINUX SERVER (Read 8129 times)

ozioma · « **on:** June 02, 2004, 10:24:32 PM »

PLEASE WHAT ARE THE STEPS I SHOULD TAKE TO CONFIGURE MY CISCO SWITCH FROM MY SERVER PLEASE I WANT TO CHANGE THE PORTS FROM HALFDUPLEX TO FULLDUPLEX LET ME KNOW THE COMMANDS

THANKS
OZIOMA

segun1ng · « **Reply #1 on:** June 06, 2004, 02:39:27 PM »

For beter and fast solution please give me the model of the cisco switch you have. and try to get the manual inplace .

I will give you all the steps you need to solve this problem ok.

ozioma · « **Reply #2 on:** June 07, 2004, 04:42:00 PM »

PLEASE THE MODEL OF MY CISCO SWITCH IS CATALYST 2950

THANKS
OZIOMA

RazaMetaL · « **Reply #3 on:** June 08, 2004, 05:31:00 AM »

humm... i´ve a cisco catalyst 3550, the commands, assuming that the port is the f0/1, are:

enable
# configure terminal
# interface f0/1
# duplex full
# speed 100
# end

Thats all ...

ahh. . don´t forget to save the modifications.
# wr mem

ozioma · « **Reply #4 on:** June 08, 2004, 09:59:17 AM »

THANKS FOR HELPING ME

OZIOMA

RazaMetaL · « **Reply #5 on:** June 08, 2004, 01:01:46 PM »

To view if your port is full or half.. type in configure terminal

# show interface status