Hi all,
i'm writting a programm to transfer data via serial port. I'd like to test it on my computer first, so i connected serial ports and wrote a simple program just to check the connection. I write one character into ttyS0 and want to read it from ttyS1. Writing works OK (numb_send = 1) but there is some problem with reading (numb_rec = -1). I think, port settings are OK.
ttyS0: Line 0, UART: 16550A, Port: 0x03f8, IRQ: 4
Baud_base: 115200, close_delay: 50, divisor: 0, closing_wait: 3000
ttyS1: Line 1, UART: 16550A, Port: 0x02f8, IRQ: 3
Baud_base: 115200, close_delay: 50, divisor: 0, closing_wait: 3000
Shall I set anything else? Thank you for your advise.
#include <stdio.h>
#include <sys/signal.h>
#include <sys/types.h>
int main(void) {
int fd1, fd2;
int numb_send,numb_rec;
char c;
char buf[5];
fd1 = open("/dev/ttyS0", O_RDWR | O_NOCTTY | O_NONBLOCK);
if (fd1 < 0) {
//perror(devicename);
exit(-1);
}
fd2 = open("/dev/ttyS1", O_RDWR | O_NOCTTY | O_NONBLOCK);
if (fd2 < 0) {
//perror(devicename);
exit(-1);
}
scanf("%c",&c);
numb_send = write(fd1,&c,1);
numb_rec = read(fd2,buf,sizeof(buf));
printf("sent: %d\n received: %d\n",numb_send,numb_rec);
printf("%s\n",buf);
close(fd1);
close(fd2);
}
