Author Topic: Shapecfg -- how to configure ?? (Read 9390 times)

sathish · « **on:** February 16, 2004, 04:32:31 PM »

Hello All !!!

May I know how to configure the shapecfg the bandwidth traffic shaper. I am using RedHat 9.0. I have done masq to share the net.

We are having 50 windows clients in the office. Bandwidth is 256kbps..

1. eth0 - is public IP
2. eth1 - is private IP (192.168.1.1).

Plz help me regarding this...!! how to do this ??

Thanks a lot ......

Sathish

dragoncity99 · « **Reply #1 on:** February 16, 2004, 06:02:03 PM »

Please refer the documentation for RH9 under redhat's official website.

http://www.europe.redhat.com/documentation/HOWTO/Net-HOWTO/x1415.php3

But i encourage u to use squid as a bandwidth manager rather than using squid. It's design actually to narrow down ur bandwidth for sub-routers from a main router.

sathish · « **Reply #2 on:** February 16, 2004, 06:32:11 PM »

Quote from: "dragoncity99"

Please refer the documentation for RH9 under redhat's official website.

http://www.europe.redhat.com/documentation/HOWTO/Net-HOWTO/x1415.php3

But i encourage u to use squid as a bandwidth manager rather than using squid. It's design actually to narrow down ur bandwidth for sub-routers from a main router.

Tx for ur reply........dragon

can i get a online tutorial for about squid as a bandwidth manager.. i'll try

Thanks...

Sathish

Ricky · « **Reply #3 on:** February 17, 2004, 05:16:15 AM »

Well for squid.. you have to first install it.. See the tutorial i have posted in how to section of this forum..ie. linuxsolved.com and then learn how to use delay pools.
If you want to have bandwidth control then you can make group of 4-5 terminals using there ip address and then make different delay pools for each.
Offcourse you will need dhcpd to make sure that every client is getting same address every time.. ie.. using mac address to assign same ip again n again.. !!